Aluminium Honeycomb Board

TOOLS FOR ROUTING AND FOLDING
The following points must be taken into consideration:
The edges should not be bent back and folded a second time.
The width of the base cutter edge must be 2mm.
The grooves should basically be routed in the 1 mm thick cover sheet.
After routing the remaining metal sheet must be 0.8mm thick

Cutter disk for V-grooves 90°
For panel thicknesses of 6 and 10 mm a milling cutter for 90° V-grooves
with a cutter edge width of 20 mm must be used on circular panel saws.
Customized design by ALULOYAL.
Supplier for cutter disks for V-grooves and special saw blades

End milling cutter for V-grooves 90°
With cylindrical shank of the corresponding diameter for all panel thick-
nesses. Customized design by KWO.
Supplier for end milling cutters

Milling cutter for rectangular grooves for aluminium honeycomb board  10mm with additional pre-cutter for aluminium honeycomb board 15, 20 and 25mm Instead of the milling cutter for rectangular grooves a special saw blade, as shown on page 11, may also be used. Customized design by 

Please ask for details.
Supplier for cutter disks for rectangular grooves and for pre-cutters