How To Bend Aluminum Composite Panel

Nov 08, 2026

Leave a message

wo main ways to bend ACP / ACM (aluminum composite panel)

Important rule: Always keep the protective film on during bending to avoid scratching PVDF/polyester coating. Bend slowly; cold bending only - do NOT heat ACP to bend it.

1. V‑groove routing + folding (for sharp 90°, 135° corners, cassettes, sign returns - most common for facade & sign shop)

This is how you get crisp square bends, the standard "rout & fold" method

Mark the fold line on the BACK (non‑visible side)

Use a CNC router / hand router with 90°–110° V‑groove bit

Critical depth setting: Remove core material, but leave 0.2–0.3 mm thin core layer above the front aluminum skin. ✅ Do NOT cut through the front aluminum skin - it will crack later under wind/thermal movement Example for your 1/4" (6.35 mm) ACP: groove deep enough to leave that ~0.3mm safety layer

Deburr the groove, clean dust

Bend toward the grooved side (the groove becomes the inside of the corner). Bend gradually, do not snap it.

Hold or clamp for a short time to set the angle; springback is small on routed folds.

Best for: facade cassette returns, sign letter backs, box shapes, internal corners. ❌ Not for large smooth curved surfaces.

2. Cold roll bending / press brake bending (for gentle continuous curves, columns, curved walls)

No V‑groove. You bend the whole panel as a sandwich panel.

Use 3‑roll bender, pyramid roller, or press brake with rounded soft dies

Minimum bend radius rule (PE core ACP): generally R = 10 × panel thickness

¼" (6.35 mm) ACP: safe minimum inside radius ≈ 65 mm

A2 mineral core ACP is stiffer: R = 20~25 × t, harder to bend, easier to crackalucobond....

Roll slowly, evenly; over‑bend 3–5° to compensate for springback

Rollers must be smooth, clean; use protective film between roller and panel surface

You can only make single‑axis curves (cylinders). Double curvature (bowl shape) is not practical with standard ACP.

Best for: curved column cladding, rounded building corners, curved signage faces. ❌ You cannot get a sharp 90° corner this way.

Common mistakes that ruin panels

Cut the V‑groove too deep, nick the front aluminum skin → coating cracks, delaminates outdoors

Bend the wrong direction (groove on outside) → front skin stretches and cracks

Remove protective film before bending → scratches on PVDF finish

Try to cold‑bend below the rated minimum radius

Heat the panel with torch / heat gun: PE core melts, lamination fails

Bend when temperature <15°C (59°F): coating becomes brittle, easy to craze

Quick comparison for your 1/4" (6.35 mm) ACM

Method Result Min Radius Typical use
V‑groove rout & fold Sharp 90° corner ~3–4 mm internal corner radius Facade cassettes, sign boxes
3‑roll cold bend Smooth arc ~65 mm Curved walls, round columns

Extra fabrication note for your ACP manufacturing business

When you supply bent ACP to clients, always state clearly:

Whether it is routed fold or cold rolled curve

Minimum bend radius

Skin thickness and coating type (PVDF is less flexible than plain polyester)

Fire grade (A2 mineral core bends much harder than PE core)

 

Send Inquiry
Our vast sales and service network spans 23 provinces
We have rich experience
and perfect equipment.
contact us