How To Cut A Hole in Aluminum Composite Panel

Nov 10, 2026

Leave a message

How to cut holes in ACP / ACM (aluminum composite panel)

Core rule: Keep protective film on; support the back; avoid heat - heat melts PE core and causes delamination. Four common methods, sorted from small holes to large / irregular cutouts.

1. Small round holes (drill bit, for fastener holes)

Best for screw / rivet holes, 3 mm ~ 12 mm

Mark position, use a center punch to make a tiny indent so the bit does not wander

Clamp panel down, put plywood backing under the hole (stops breakout)

Use 135° split-point HSS or carbide drill bit for aluminum

Drill at medium-low speed, light steady pressure; lift the bit often to clear chips

Deburr both sides with a deburring tool or 400–600 grit sandpaper

For exterior fixing: drill hole 2–3 mm oversized for thermal expansion (critical point you put in your installation guide) ⚠️ A2 mineral core ACP is brittle - feed even slower, easier to crack around holes.

2. Medium/large round holes (hole saw, 15 mm up to ~100 mm)

Pipes, conduit cutouts, speaker holes

Center pilot drill first, plywood back support

Use bi-metal hole saw (for non-ferrous metal), sharp teeth

Slow speed, light feed; pull out repeatedly to clear melted PE plastic

Do not force it. If smoke appears → stop, you are overheating the core

Clean melted core residue from the edge after cutting

3. Irregular / square cutouts (jigsaw)

Outlet boxes, custom shapes

Inside your marked cutout area, drill a starter hole big enough for the jigsaw blade

Keep the good finished side facing up

Use fine-tooth blade for metal / plastic

Cut slowly, steady feed; support the waste piece so it does not tear the panel at the end

File or sand rough corners

4. High-volume / clean precision (CNC router, waterjet, turret punch)

Factory production:

CNC router: single-flute up-cut bit, moderate feed + vacuum chip removal, best clean edge for batches

Waterjet: cold cut, zero heat, excellent for A2 fire-rated panels; no melting, no delamination risk

Turret punch: only good for PE core ACP; not recommended for mineral A2 core, it chips and cracks easily

Critical mistakes to avoid (very important for your customers)

Remove protective film before cutting → scratches on PVDF surface

No backing under panel → aluminum skin tears / peels on exit side

High speed + heavy pressure → heat melts PE core, delamination starts at hole edge

Using wood hole saw / dull blades → jagged edges, core stringing

Drilling too close to panel edge: minimum edge distance ≥ 2× panel thickness

Leave melted plastic stuck on hole edge: over time this traps moisture and starts delamination outdoors

Quick spec note for your TDS

PE core ACP: forgiving, easier to drill / hole saw

B1 mineral core: slower cutting, more brittle

A2 non-combustible core: highest care, waterjet or CNC preferred over hole saw

After cutting, you can seal raw hole edges with edge sealant for exterior facade use to block water ingress

 

Simple comparison

Method Shape Best size Surface quality
Twist drill Round 3–12 mm Good
Bi-metal hole saw Round 15–100 mm Fair–good
Jigsaw Any irregular Medium cutouts Fair
CNC / Waterjet Any All sizes Excellent
Turret punch Round / simple shapes Mass production OK only PE core
Send Inquiry
Our vast sales and service network spans 23 provinces
We have rich experience
and perfect equipment.
contact us